Thursday, August 19, 2010

Extruder Attachment part 2

Someone contacted me and asked for close up photos of my extruder attachment for a caulking gun seen in this post. My husband works with stainless steel so that is what he used to make it with.

It is just stainless steel plates, cut and welded to a stainless steel pipe. The pipe is a larger diameter than my extruder so I have masking tape wrapped around it to prevent it from moving around inside the pipe.

This is the bottom where the clay comes out when you squeeze the handle of the caulking gun.

Hope that helps.

0 Smooshing Thoughts: